Yamaha YDRE Serie Benutzer-/Betriebsanleitung Seite 34

Visually and manually inspect to
verify that the DC output cord,
plug and battery charging
receptacle are in good working
condition before each and every
use. Do not use the charger under
any of the following conditions:
• The DC charging receptacle does
not grip the DC cord set plug
tightly, is loose or does not make
a good electrical connection.
• The DC cord set plug or charging
receptacle feels hotter than
normal.
• The DC cord set plug or charging
receptacle contacts are bent,
corroded, or are dark or bluish in
appearance.
• The DC cord set plug, cords,
receptacle or equipment
charging wiring are cut, worn,
broken or have any exposed
conductors.
• The DC cord plug, cords, charger,
or receptacles are damaged or
distressed in any way.
Using the charger with any of the
above symptoms could result in a
fire, property damage or personal
injury.
Do not disconnect the DC cord set
plug from the charging receptacle
when the charger is on. If the
charger must be stopped, first
disconnect the AC power supply
cord from its AC outlet, and then
disconnect the charger DC cord
set plug from the charging
receptacle.
JW2
MAINTENANCE
Whenever removing AC or DC cord
set plugs from receptacles, pull
from the plug body and not from
their respective cords.
The instructions printed on the
charger (shown below) are for daily
reference. The charger is factory
preset for use with Trojan 48-volt golf
car batteries.
OPERATING INSTRUCTIONS
1. PLUG AC CORD INTO A
GROUNDED RECEPTACLE
2. PLUG DC CORD INTO GOLF
CAR RECEPTACLE
3. CHARGE CYCLE WILL BEGIN
AFTER A FEW SECONDS AND
AMMETER WILL TURN ON
4. CHARGER SHUTS OFF AUTO-
MATICALLY WHEN BATTERIES
ARE CHARGED
Connect charger's AC cord set to AC
power. Then, connect the DC cord
set plug to the vehicle charging
receptacle by grasping the plug
handle and pushing the plug straight
into the receptacle. The charger will
start automatically.
Upon connection to AC power
source, the lower four LEDs come
on as a Power-On Self-Test, then the
AC power LED turns on. Upon
connection to battery pack, output
indicators turn on to indicate charging
is active.
1
2
3
4
5
6
7
8
9
10
11
7-7