Wireless Sensor - Insert Batteries; Wireless Sensor; Sensor Data Transmission - Oregon Scientific RGR126NX Bedienungsanleitung

1. Insert the batteries, matching the polarity (+/-) as
shown in the battery compartment.
2. Press RESET, or press and hold SEARCH on the
main unit to initiate operation. The reception icons
( and ) on the main unit will blink while it is
searching for the sensor or rain gauge.
NOTE The main unit returns to default settings in each
battery replacement.

WIRELESS SENSOR - INSERT BATTERIES

1. Remove the battery compartment cover by screw driver.
2. Insert the batteries, matching the polarities (+/-).
3. Press RESET after each battery change.
LOCATION MEANING
Rain collector sensor
Rainfall area
batteries low
Outdoor temperature area Outdoor sensor batteries low
Clock area Main unit batteries low
RGR126NX_UM_EN_R1.indd 6
NOTE Use alkaline batteries for longer usage and consumer
grade lithium batteries in temperatures below freezing.

WIRELESS SENSOR

The main unit can collect data from up to two (2) sensors,
including one rain gauge and one outdoor thermo sensor.
To set up the sensor:
1. Open the battery compartment.
2. Select a channel then press RESET.
3. Close the battery compartment cover.
4. Place the sensor within 100 m (329 ft) of the main
unit using the table stand or wall mount.
TIP For accurate readings, ideal
placements for the sensor would
be in any location on the exterior
of the home at a height of no
more than 1.5 m (5 ft); and can
shielded it from direct sunlight or
wet conditions.

SENSOR DATA TRANSMISSION

To search for a sensor:
SEARCH.
area shows the status (see below).
6
150cm(5ft)