Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Luxstat
Project planning
Luxstat Control – lux setting
Calculation form
Documentation of settings
Project:
No.:
Location:
Date:
Lux range:
+
Measurement of indoor light (without artificial
light) "Lux indoor":
Required light level "Setp":
Light sensor – lux value:
Servodan A/S | Tel +45 7442 4726 | Fax + 45 7442 4035 | info@servodan.dk | www.servodan.com
Check
Check lux range on sensor:
3-300 Lux
300-30.000 Lux
Measure and set
Zone 1
Lux indoor 1:
Lux
Set with Lx 1
Factory setting for light level: 300 Lux.
If other set points are chosen, please note here.
Setp. 1:
Lux
Set with Set 1
Reference measurement
As documentation of the daylight factor, measure the lux value at the light
sensor. The measurement must be made under the same conditions as the
measurement of "Lux indoor" .
Lux value at the light sensor, measured with luxmeter:
090825KOE 77-050 Luxindstillingsskema R2 GB.doc
Factory settings:
Applikation: ............................................... App. Class room.
Lux 1 indoor (Lx 1): ................................... 200lx
Setpoint 1 (Set 1): ..................................... 300 lx
Lux 2 indoor (Lx 2): ................................... 150lx
Setpoint 2 (Set 2): ..................................... 300 lx
Off delay (Time): ....................................... 10 min.
Vout max 1-10V (Dim up/Dim down): ....... 10V
Relay On/Off (Off delay + 10 min.):............ 20 min.
Operating:.................................................. Pushb. 1 for On/Off and
dimming of ceiling light Pushb. 2
for On/Off of Black board light
Under factory setting, a light sensor value of 450lx is used for
calculating the daylight factor..
Luxstat Control type:
Minilux Sensor type:
Application: Class Room:
30-3.000 Lux
600-60.000 Lux
Lux indoor 2:
Set with Lx 2
Setp. 2:
Set with Set 2
77-050
Auto:
Man.:
Zone 2
Lux
Lux
Lux
17(17)
Werbung
