Rack Mount Installation; Hardware Installation; Installation Precautions - D-Link DGS-1008MP Installationsanleitung

Rear Panel Connectors
100-240V AC 50/60Hz
Power Cord Retainer
3 2
Figure 3: Rear panel connectors
# Connector
Kensington
Slot used to attach a physical
1
Security Lock Kensington security lock.
Screw used to secure a grounding
2 SWITCH GND
wire to connect the switch to ground.
3 DC Power Input Input jack for the power adapter.
Table 3: Rear connector description

Hardware Installation

Installation Precautions

For safe switch installation and operation, it is
recommended to:
• Visually inspect the DC power jack and make sure
that it is fully secured to the power adapter.
• Make sure that there is proper heat dissipation
and adequate ventilation around the switch.
• Install the switch in a site free from strong
electromagnetic sources, vibration, dust, and
direct sunlight.
• Not place heavy objects on the switch.
Grounding the Switch
The following steps explain the procedure for
connecting the switch to a protective ground:
1. Verify that the system is powered off.
2. Remove the ground screw and place the #8
terminal lug ring at one end of the ground cable
on top of the ground screw opening.
3. Insert the ground screw back into the ground
screw opening.
4. Using a screwdriver, tighten the ground screw to
secure the ground cable to the switch.
5. Attach the terminal lug ring at the other end
of the grounding cable to an appropriate
grounding source.
DGS-1008MP
1
Description
6. Verify that the connections from the ground
connector on the switch to the grounding source
are securely attached.
Attaching the Rubber Pads
The DGS-1008MP comes with a strip with 4 adhesive
rubber pads to place on the bottom of the device
to prevent the switch from damaging the surface
it is placed on. To attach the rubber pads, simply
remove the rubber pads from the adhesive strip and
stick one pad on each corner on the bottom panel
of the switch.

Rack Mount Installation

The switch can be mounted in an EIA standard size
19-inch rack, which can be placed in a wiring closet
with other equipment.
1. Attaching the L-shaped mounting brackets to the
sides of the switch and secure them with screws
provided.
2. Mount the switch in the rack using a screwdriver
and the supplied rack-mounting screws
Powering On the Switch
After connecting the switch to the network using
a compatible category 5/6/7 UTP network cable,
simply connect the switch to a power outlet to power
the device.
TECHNICAL SUPPORT
dlink.com/support
3