Initial Settings; Quick Edit - Pandora PX4 Bedienungsanleitung

Initial Settings

1. When you finish making connections, set the
power switch in the "ON" position. (This set-
ting is referred to as Play mode.)
Use the L/M buttons to select a program.
2. Set the input level switch to a position appro-
priate for the output level of your guitar.
Hi: Guitars with a high output level
(humbucking pickups)
Lo: Guitars with a low output level
(single coil pickups)
3. Set the volume control of the guitar to its usual
position.Use the Value dial to adjust the mas-
ter level.
If you want to use the infrared transmitter func-
tion, refer to p.26 of Edit mode, "9) TX (infrared
transmitter)."

Quick Edit

In each mode (except when Mute/Bypass or Key
Lock are active), you can use the Amp Model-
ing selector to quickly change the amp model-
12
ing type, or use the control knobs to adjust the
gain, tone, or volume of amp modeling. When you
move a control knob, the parameter name and
value will appear for several seconds in the val-
ue display. If the setting matches the original set-
ting, the ORIG icon will light.
The Delay Time of Delay Modeling can also be
set by pressing the TAP button twice at the de-
sired interval (except when in Rhythm & Bass
mode). To check the Delay Time that was speci-
fied, press and hold the TAP button for two sec-
onds or longer.
Program name
Input level
switch
Amp selection
Amp gain, tone,
and volume
Program
number
Set the
delay time
Master level
adjustment
Program selection