Troubleshooting; Technical Specifications - Pic Solution Mister 8 Bedienungsanleitung

• Fit the filter cover cap back on.
WARNING! Never leave the filter cover cap and/or filters unattended: These are small parts posing the risk of
suffocation if swallowed by children.

TROUBLESHOOTING

PROBLEM
Scarce nebulisation
Scarce nebulisation
No nebulisation
No nebulisation
Slow nebulisation

TECHNICAL SPECIFICATIONS

External power supply:
Service life in storage conditions:
Service life of accessories:
Frequency:
Maximum flow:
Operational flow:
Max pressure:
Operational pressure:
Conditions of use:
NEB RATE:
MMAD:
Weight of the Mister 8 [without accessories]: ~800g
Nebuliser cup capacity:
Breathable fraction:
CAUSE
Nebuliser cup clogged
Nebuliser cup clogged
Components of the nebuliser cup
assembled incorrectly
The compressor does not work
Medicine too thick
100-240 VAC 50/60Hz 0.6A 12V 2A
02010298000000 (EU plug)
02010299000000 (UK plug)
5 years
1 year
50/60 Hz
12 ± 2l/min
5 ± 1l/min
2 ± 0.4 bar
0.6 ± 0.18 bar
20' ON – 40' OFF at 40°C
> 0.30 ml/min
< 3 μm
Max 10ml; Min 2ml
> 75%
15
SOLUTION
Remove and disconnect all nebu-
liser cup components and clean
them according to the instruc-
tions provided in this instruction
manual.
If the problem remains after clean-
ing, replace the nebuliser cup.
Disassemble and reassemble the
nebuliser cup. If the problem re-
mains, replace the nebuliser cup.
Check whether the AC/DC adapter
plug is disconnected from the
mains socket, check that the ON/
OFF button is ON, that the mains
socket is operational, and that the
AC/DC adapter power supply ca-
ble pin is connected to the device
socket (N).
Dilute the medicine as specified
by the pharmaceutical company.