Safety Notices For Chargers; Working Instructions For Sawing; Original Accessories / Tools; Information About Saw Blades - FLORABEST FAAS 10.8 A2 Bedienungs- Und Sicherheitshinweise

... / Safety notices for chargers / Working instructions for sawing / Before using
After switching off do not stop the saw
blade by pressing it sideways against
an object. The saw blade could be damaged,
brake, or cause kickback.
Secure the material well. Do not sup-
port the work piece with your hand or
foot. Do not touch objects or the ground
with the saw running. Risk of kickback.
Secure the work piece. Use clamps or a
vice to firmly hold the work piece. This results
in a safer grip than with your hand.
Wait for the power tool to stop before
putting it down. The tool being used could
catch, resulting in losing control over the pow­
er tool.
Lock the on/off switch to the off posi-
tion before working on the power tool
(e.g. maintenance, tool change, etc.),
and when transporting or storing. Risk
of injury if the on/off switch is accidentally acti­
vated.
Protect the power tool from heat, e.g.
also from continuous sunlight, fire,
water and moisture. Risk of explosion.
Wear the dust mask when using the tool.
S afety notices for chargers
This device may be used by children age 8 years
and up, as well as by persons with reduced phys-
ical, sensory or mental capacities, or lacking
experience and/or knowledge, so long as they
are supervised or instructed in the safe use of
the device and understand the associated risks.
Children should not be allowed to play with the
device. Cleaning and user maintenance should
not be performed by children without supervision.
The charger is only suitable for
indoor use.
the cable, mains cable, or plug are damaged. A
damaged mains cable indicates a life-threaten-
ing danger due to electric shock.
40 GB/MT
Do not operate the device if

Working instructions for sawing

Check the material you wish to cut for foreign
objects such as nails, screws, etc. and remove
these.
Immediately switch off the tool if the saw blade
is jammed. Spread the previously cut slit with a
suitable tool and remove the sabre saw.
S aw the material with an even feed motion.
O riginal accessories / tools
U se only the accessories specified in
the operating instructions. Using tools or
accessories other than those recommended in
the operating instructions could result in injury.

Information about saw blades

You can use any saw blade, provided it has the
correct shank fitting - ½ (12.7 mm) universal shank.
Saw blades in various lengths optimised for any sa-
bre saw application are available from your retailer.
Note: TPI = teeth per inch = number of teeth per
2.54 cm

Before using

R emoving / charging / inserting
the battery pack
Note: The battery is partly charged at the time of
delivery. Charge the battery before use. Li-Ion bat-
teries can be charged at any time without reducing
the life. Interrupting the charging process does not
damage the rechargeable battery.
1. To remove the battery pack
buttons and slide the battery pack
4
of the tool.
2. Insert the rechargeable battery pack
the rapid charger
12
3. Insert the mains plug into the mains socket. The
status LED will light up red.
14
press the release
3
out
3
into
3
.
®