Sophos SG 105w Kurzanleitung Seite 5

Power switch
Workstation connection properties:
IP address: Any address in the range
192.168.0.2 through 192.168.0.254
Netmask: Enter 255.255.255.0
Standard gateway: Enter the IP address of
the appliance's internal network card
(eth0/LAN): 192.168.0.1
DNS server: Enable this option and enter
the IP address of the internal network card
(eth0/LAN): 192.168.0.1
SG 105w/115w/125w/135w Quick Start Guide
3. Power it on
Connect the appliance to the power socket and turn it on
Connect the appliance to the power supply using the power cable from the
scope of supply.
Turn the appliance on. The power switch is on the back side of the housing
next to the power supply plug. Once the security system has booted
completely, you'll hear an acoustic signal: five beeps in a row.
4. Configure the device
Use your browser to make the initial connection to the WebAdmin GUI
You will need to configure a workstation with the necessary LAN properties
to access WebAdmin. You can change these settings later to match your
existing network. The location of the menu for these settings depends on the
operating system of your client.
Example: With Windows 7, the menu can be found under Start >> Control
Panel >> Network and Sharing Center
Start the browser and enter the management IP address of the appliance:
https://192.168.0.1:4444
Accept the security notice by clicking OK (Mozilla Firefox) or Yes (MS Internet
Explorer).
For configuration you can follow the initial setup wizard described in the
WebAdmin Quick Start Guide** or cancel it and perform a manual setup (see
the UTM Administration Guide*).
* Available via WebAdmin >> Support >> Manual
** Available at www.sophos.com/en-us/support