Sophos SG 105w Kurzanleitung Seite 4

Internet
eth1/WAN
e.g., UTM Appliance
DSL modem
Switch
Internal network
admin client PC
SG 105w/115w/125w/135w Quick Start Guide
2. Mount and connect the device
Mount the antennas
Connect the provided antennas to the connectors on the back of your
appliance and align them in a vertical position.
Connect the ports to the internal and external networks.
1) Connect the eth0/LAN port via a hub or switch to the internal network. For
this purpose, please use the RJ45 Ethernet cable of the scope of supply.
Note that your administration client PC must also be connected to this
network.
eth0/LAN
2) Connect the eth1/WAN to the external network. The connection to the WAN
depends on the type of Internet access.
The UTM appliances are shipped with the following default settings:
Internal network card (eth0)
IP address: 192.168.0.1
Network mask: 255.255.255.0
Default gateway: None
DNS proxy: Enabled
Firewall: Block all
DHCP service: Disabled
Mount the appliance to a rack
If you want to mount the appliance within a rack please use the optionally
available rackmount kit for this device.