Qviart unic Handbuch Seite 8

2. Complete the antenna settings of this satellite.
3. Highlight the Start Search and select Blind Search then press the OK button to confirm.
1. Highlight the Satellite and press the OK button to enter satellite list.
D: TP Search
2. Complete the antenna setting of this satellite.
3. Highlight the Transponder and press the OK button to enter TP list.
4. Highlight the Start Search and select Transponder then press the OK button to confirm.
1. Highlight the Satellite and press the OK button to enter satellite list.
E: Multi TP Search
2. Complete the antenna setting of this satellite.
3. Highlight the Start Search and select TP Search then press the OK button to confirm.
4. Highlight the transponders in the TP list press the OK to mark them.
5. Press Exit will start searching programs of the transponders you have marked.
4.1.4 Antenna Settings for Motor
1. Menu-> INTALLATION ->Antenna Settings->Motor
Select DiSEqC 1.2 or USALS using the / button.
DiSEqC 1.2: General motor antenna using DiSEqC 1.2. Motor Mode:
USALS: Motor antenna using USALS.
Press button, the dish will be motorized to East/West
Move Auto [W/E]
continuously; it will stop until it find the best signal
/
Press button, the dish will be motorized to East/West
Move west-east
step by step, until you find the best signal showed on the
/
signal bar.
Input digital button to set the moving step
Fine Tuning (1)
Save the current position you searched.
Store Position
Press OK button to move the dish to the position that you saved.
Go to Position
Press OK button to move the dish to 0 positions.
Go to Reference
You can set the maximum motor limit for both West to prevent damage to the antenna.
Set West Limit
You can set the maximum motor limit for both East to prevent damage to the antenna.
Set East Limit
Disable West limit and East limit.
Disable Limit
Press OK button to move the dish to the USALS Setup.
Go to X.X
Tip: Before you use USALS, you should go to Main Menu ->INTALLATION -> USALS Setup to set you local
position firstly.
7