Vertix Raptor-i Bedienungsanleitung Seite 10

Intercom Pairing
EN
Switch OFF all Raptors-i near you if possible.
Bring the 2 sets you would like to begin pairing close to each other.
Put them into Pairing Mode. You will see Red and Blue flashing lights on BOTH sets.
Press the ON-OFF/INT button briefly on ONE of the Raptor-i to initiate pairing.
When both Raptor-i show only a Blue flashing light, the pairing is completed and INTERCOM is established between the 2 sets. Test by talking to
confirm.
If you want to include a 3rd set in the group, turn off ALL the sets first and repeat the intercom pairing process for the 1st set and the NEW (3rd)
set.
NOTE: Each Raptor-i unit can only pair with 2 other Raptor-i units. The last 2 sets to pair will have a higher priority and a single INT button press on
either of these 2 units will connect them together. The 3rd or last set to pair will require 2 INT presses to communicate with either of the 2 earlier
sets.
Music Player Pairing
Refer to Mobile Phone Pairing
GPS Sat-Nav Pairing
®
Models such as the Garmin Zumo 500 and 600 series supports pairing with your mobile phone and offers an easy and convenient way for you
to enjoy both mobile phone and GPS Sat-Nav functions on your Raptor. Please see your GPS Sat-Nav user manual on setting up and if the phone
function is supported.
For GPS Sat-Nav devices without the integrated mobile phone feature, you will have to decide which one takes higher priority as Raptor-i can only
support ONE High Priority device, you may wish to note that most older or entry level GPS Sat-Nav devices does not support phone pairing.
®
Garmir is a registered trademark of Garmin Ltd or its subsidiaries.
Clearing All Paired Devices
With the Raptor turned ON, you can clear all devices paired on your Raptor by pressing the CALL CONTROL and VOL DOWN button together until
you see 2 RED flashes.
9