Haier AFD series Gebrauchsanleitung Seite 41

English
5A
6A
7D AFD
7A
8A
AFD
9A
9B
5B
6B
7B
7C
7C
8C
8B
AFD
Door reversibility: mounting door from the left
5 A) Take the central hinge, and with the aid of pliers, unscrew
the pin, turn it upside down and re-fasten it on the
hinge.
5
B) With the help of a normal screwdriver, withdraw the three
hole-covers of the central cross piece from the left, and
D
re-install them on the right.
6 A) Take the central hinge and turn it through 180°C;
B) fasten it with the screws on the left of the central cross-
piece.
B
7 A) Slightly loosen the screw (already fitted) on the top left
side of the appliance.
B) Take the top hinge and turn it upside down;
C) remove the pin (now high up) from the hinge and fit it in
its lower part;
AFD
D) for
compartment and provisionally let it hang from the
6
appliance.
D
8 A) Take the refrigerator door, and insert it on the pin of the
central hinge,
B) Fit the upper hinge on the door and take it toward its
location on the appliance
C) Insert the hinge slot on the screw at the left (loosened in
step 7A);
secure the appliance's hinge, fastening two screws on
it.
AFD
For
7
in step 7D) inside the top slot of the hinge (see drawing
C
9B):
AFD
9 For model only:
A) transfer the display cable, located in the slit above the
refrigerator door, from left to right, always keeping it
inside the slit;
B) route the cable inside the hinge slit under the door cross-
beam and unite the two display cables.
10 A) Click-fit the head (previously removed) on the top side
of the refrigerator door.
B) Click-fit the front panel, applying pressure on several
points;
8
C) secure it with two screws;
D) fit the clips on the right and left sides (previously
C
removed).
1 C
10D
AFD
9
C
10A
19
model only: extract the display cable from the
model only: insert the display cable (removed
10B
10D
10C
10
C