Power Connection & Charging; Replacing The Fuse - Snooper Syrius Pro Benutzerhandbuch

Powering and charging S7000 from the cigarette lighter socket
S7000 comes with a power cable designed to plug into your vehicles cigarette lighter socket. The power cable is suitable for both 12v
DC and 24v DC vehicles. This lead will power the device but will also charge S7000's internal battery.
1. Push the 'Batt. ON/OFF' switch on the back of the unit to the 'ON' position
2. Then plug the smaller end of the lead into the power socket on the right hand side of S7000
3. Plug the other end of the cigarette lighter adaptor into your vehicles cigarette lighter socket.
If S7000 is powered using the cigarette lighter socket a Red LED will illuminate on the left hand side of the unit. When the
battery is fully charged, the Red LED will turn Green.
4. When you connect the in car charger the unit will switch ON automatically.
Please Note: Do not leave S7000 plugged into the cigarette lighter socket when you start your vehicle. The cigarette lighter
socket is prone to power surges as the vehicle is started and this may cause damage to your unit.
If S7000 does not power up please check that the cigarette lighter socket is clean of any debris, remembering not to insert metal
objects into the socket. Check that the cigarette lighter adaptor is inserted all the way into the socket and check that the fuse in
the cigarette lighter adaptor is operational. If S7000 will still not power up, please check that the cigarette lighter in your vehicle is
functioning correctly.
If S7000 stops operating, the fuse in the cigarette lighter plug may have blown . If it has blown, follow these steps and replace it with
a 3 amp, 6 x 30mm fast acting fuse.
Caution: Using a fuse that does not meet these ratings or defeating fuse protection can damage your unit, the power
cable, or the vehicles electrical system.
1. Grasp the ring near the tip of the cigarette lighter plug, and then carefully unscrew the ring by turning it counter clockwise.
Caution: If you must use pliers to loosen the ring, be careful not to crush the tip. Never use pliers or other tools to retighten the
ring on the cigarette lighter plug.
2. Pull the ring straight out, then remove the metal tip and old fuse.
3. Check the fuse to see if it has blown. If it has, replace it.
4. Replace the metal tip inside the ring, then place the fuse inside the cigarette lighter plug and screw the ring back onto the plug.
Make sure the metal tip is visible when you reassemble the cigarette lighter plug.
Return to contents
Power Connection & Charging
Replacing the Fuse
12 • UK