Tr Oubleshooting - USRobotics USR805436A Installationsanleitung

Tr oubleshooting

For Macintosh and Linux assistance, refer to the Troubleshooting section in the
User Guide on the Installation CD-ROM.
Basic Troubleshooting Procedure
This procedure addresses a number of symptoms that you might experience with
your print server:
1. Verify the physical cable connections between the print server, the printer,
your router, and your power outlet.
2. Ensure that the power outlet to which the print server is connected is a live
outlet.
3. Refer to the LED descriptions at the beginning of this guide and then check
the LEDs on the print server to make sure you are receiving power and that
there is not a print error.
If you still have trouble using the phone, follow the procedure below that best
describes your symptom.
My Setup Wizard cannot detect the Wireless USB Print
Server.
S o l u t i o n :
Restore the factory default settings of the print server and repeat the installation
procedure. To restore the factory default settings:
1. Unplug the power adapter from the print server.
2. Press and hold the
3. Plug the power adapter back in to the print server.
4. Release the
RESET
At the end of the Setup Wizard, I receive a message that says
"Network busy, or device not found".
S o l u t i o n :
On the main menu of the U.S. Robotics Installation CD-ROM, click
and then click
Installs
installation procedure.
My Wireless USB Print Server is not appearing in the Printer
Port Setup screen.
S o l u t i o n :
Restore the factory default settings of the print server and repeat the installation
procedure. To restore the factory default settings:
button.
RESET
button.
. Follow the on-screen instructions to continue the
User
English
Additional
5