bca Float 18 Benutzerhandbuch Seite 8

Equipment Check
Be sure to complete the following steps before each use of your Float avalanche airbag pack.
Refer to the numbered images and diagrams for visual reference.
The compressed air system (see page 7) is identical in every BCA Float pack. However, each size
Float (18, 30 and 36) has slightly different pack features. To reach the compressed air system, follow
the directions for your specific pack.
Float 18: Unzip the main compartment, then unzip the interior zipper. Move the shovel and probe
sleeves to the side.
Float 30: Unzip the main compartment, then unzip the interior zipper.
Float 36: Unzip the back panel access zipper.
System Fittings
Check the quick connect fitting
w
(see page 7) to make sure it is attached securely. The plastic coupler gauge
ensure the system is properly connected.
Unscrew the trigger cover
{
trigger pin . Replace trigger cover.
Air Cylinder
Check the pressure gauge
and 2700 psi (172 to 186 bar) at room temperature (approximately 70°F or 21°C). Pressure must
5
8
u
between the compressed air cylinder
y
and make sure the trigger cable nut and make sure the trigger cable nut
WRONG
1
|
on the compressed air cylinder and make sure it is between 2500
6
TRIGGER CABLE NUT ATTACHED
5
z z
7
6
5
v
and the air hose
x
must fit in place to
is attached securely to the is attached securely to the
4
SECURE
1