REVIER MANAGER Fallenalarm Benutzerhandbuch Seite 27

Choose the way of alerting as well as the amount of daily reports and the
time.
Please note: The time of the LTA must be correct (see page 27 -
"Set Clock"). Otherwise the daily reports will not be sent at the right time.
Menu item [Call & Listen]
In this menu item you can define how long you can call back
the LTA after an alarm has been triggered (see page 28 -
"Call back the LTA after alerting").
Menu item [Rename]
You can change the name of the LTA. It will be written in the alarm SMS.
Following characters are allowed: 0-9, a-z, A-Z, _
Menu item [Change Password]
The default setting is 0000. In this menu item you can change the
password.
Menu item [MIC volume]
Set the sensitivity of the LTA's microphone.
Menu item [Set Clock]
Set or change the time of the LTA.
Menu item [Check Status]
Inquire the defined settings of the LTA, they will be shown in the menu
item [Record].
If you have finished the configuration, you can remove the
magnet from the [SETUP] slot.
If you do not send a command within 10 minutes, the LTA will go into
the standby mode and the flashing of the LEDs will stop. If you want to
continue the configuration, remove the magnet and install it again.
27