EN
•
Never bend or curve the ÉPIX Flex 20 past the minimum bending diameter: 2 in (50 mm).
•
Never use blunt force on the ÉPIX Flex 20.
•
When installing the ÉPIX Flex 20 on the floor, make sure the product and cables are not in the way of people
or vehicles.
•
Never throw the ÉPIX Flex 20! Handle with care.
•
Never puncture or cut the product in any way other than described under
•
When installing the ÉPIX Flex 20 in a channel, never push in from both directions. Press the product from
one end to the other, in one direction.
•
Never install the ÉPIX Flex 20 in a way which applies stress to the cables. Excessive force or twisting may
damage or destroy electrical connections or connectors.
•
Never dangle, hang, or suspend the ÉPIX Flex 20. The product must always be secured to a surface every
1.6 ft (0.5 m).
3
QUICK REFERENCE GUIDE
Cutting to
Length.
ÉPIX Flex 20 QRG Rev. 4