Transmitter Controls - Audio-Technica 1800 Serie Installation Und Betrieb

10
E
N
a
ATW-T 1801 UniPak
ATW-T 1802 Plug-on Transmitter Controls
Antenna 1 The ATW-T 1801 UniPak
best results, allow the antenna to hang freely and full length from the bottom of the transmitter. If
the received signal is marginal, experiment with different transmitter positions or try
repositioning the receiver. Since the transmitter antenna simply screws in, check to make certain
it is snugly attached (finger-tight).
Power-on LED 2 Green light indicates power is on and un-muted; red light indicates that audio is muted.
The light will blink when the batteries are low.
LCD 3 Liquid Crystal Display presents setup and operating information. The LCD in the transmitters is
designed for greatest contrast and best viewing with the window rotated somewhat away from
the viewer (about 30 degrees), not straight-on, for a more convenient holding/viewing
position. The display is illuminated with a backlight when you press Set to access transmitter
functions. The backlight will automatically turn off within a set period of time.
Audio Input Jack 4 Connect an audio input device (microphone or guitar cable) to the audio input jack on the bottom of
the ATW-T 1801 UniPak
microphones and cables are available separately, pre-terminated with a compatible input
connector ( see page 14 ). The cable connector latches automatically when inserted into the
transmitter jack. To unlatch and remove the connector, pull up on the connector's knurled
metal collar.
Microphone Input
5 The ATW-T 1802 plug-on transmitter has a 3-pin XLRF-type input connector with a locking collar.
Use either a dynamic or a condenser microphone. The transmitter provides power to condenser
microphones rated to operate on 12V phantom power or less. To attach the microphone, rotate the
threaded locking collar fully clockwise ("down") until it reaches the transmitter housing ( see
left ). Press the microphone and transmitter together ( see
"up" until it is firmly against the end of the mic ( see
attached before use. To detach the microphone, reverse the steps above. Always loosen the
c
b
threaded collar fully before attempting to disconnect the mic.
Power/Mute Button
6 For on/off and mute functions.
Up/Down Arrows
7 Press Up or Down arrows, in conjunction with the Set button, to choose operating frequencies
and access transmitter functions.
Set Button
8 Use in conjunction with the Up/Down arrows, to choose operating frequencies and access
transmitter functions.
Sliding Control Cover
9 This 3-position sliding cover on the body-pack transmitter's control panel prevents accidental
(3-position)
shut-off or channel-switching.
Sliding Control Cover
10 This sliding cover on the plug-on transmitter's control panel helps to prevent accidental shut-off
or channel-switching.
Battery Door
11 Open by sliding the catch down (on body-pack) or pushing in direction of arrow (on plug-on transmitter).
Mounting Clip
The ATW-T 1801 UniPak
12
either "up" or "down," depending upon which is preferred for the application. To turn the clip
around, spring the ends of the clip out of the two holes on the sides of the transmitter case and
reinstall it facing in the opposite direction.
™ Body-pack &
1
2
3
6
POWER
MUTE
SET
7
9
™ body-pack transmitter includes a field-replaceable flexible antenna. For
Do not change the length of the transmitting antenna.
™ Body-pack Transmitter. A number of Audio -Technica professional
™ transmitter's mounting clip may be installed with the case positioned
4
10
12
8
7
11
8
11
b at left ). Rotate the threaded collar
c at left ). Make certain the mic is securely
5
3
2
6
a at