E-Mu 1616 Schnellstartanleitung Seite 3

Mana GS.fm Page 3 Thursday, March 10, 2005 2:59 PM
Connecting the MicroDock to the 02 CardBus Card
Connect the supplied EDI cable from the RJ-45 jack on the E-MU 02 CardBus card labeled "EDI" to the matching connector
labeled "EDI" on the MicroDock.
The cable type is a standard CAT 5e network cable which is specially shielded to prevent RF emissions. Contact E-MU
Systems if you need a replacement cable.
CAUTION: Do not connect the MicroDock or 02 CardBus Card to Ethernet or network connectors. Doing so may
result in permanent damage to either your computer, the E-MU hardware or both.
Supplying Power to the MicroDock
The MicroDock is powered from the supplied +48VDC Adapter. Connect the Adapter to the jack marked +48VDC on the
back panel of the MicroDock. Turn the MicroDock on by turning the Headphone Volume control up.
+48V DC Adapter
02 CardBus Card
If you are currently using the Creative Audigy 2 ZS Notebook Sound Blaster, you should UNINSTALL the Creative
software and drivers from your PC BEFORE installing the E-MU drivers. Once the E-MU drivers have been success-
fully installed, you should be able to reinstall the Audigy 2 ZS drivers if desired.
48 VDC
+ -
EDI
Important - Read Before Installation
The Headphone
Volume Control is
also the Power Switch.
Getting Started - 3