Warranty - Felisatti AP110/1400SE Bedienungsanleitung

vibration load over the whole of the period of working.
ACCESSORIES
Accessories and their corresponding order number
can be found in our catalogues.
No Description
1 Brush (nylon with abrasive fill)
Felisatti (for heavy brushing)
110*100 mm, k 60
2 Brush (nylon with abrasive fill)
Felisatti (for heavy brushing)
110*100 mm. k 80
3 Wire brush Felisatti 110*100 mm
4 Brush with nylon bristles Felisatti
110*100 mm
5 Polishing brush Felisatti 110*100
mm
6 Polishing brush Felisatti (without
abrasive) 110*100 mm, k60
7 Combines brush Felisatti 110*100
mm?, k80
8 Brush of non-woven
110*100 mm, k80
MAINTENANCE AND CARE
1. MAINTENANCE
WARNING! Always unplug the machine before carrying
out work on it.
- Inspect the tool: Using a worn accessory will diminish
the efficiency of the work and could damage the motor.
- Inspect the mounting screws: Regularly inspect
all the mounting screws and ensure they are firmly
tightened.
Should any screw be loose, tighten it immediately.
Failure to do so could put you at serious risk.
- Motor maintenance: Always take the greatest care
over this and make sure that the motor winding is not
damaged and does not become wet with oil or water.
- The vents should always be kept clean and free of
obstacles.
- Clean the machine thoroughly after each use. Blast
the motor regularly with compressed air.
- Check that the mains lead is in good condition. If
it is not, take it to an Official Service Centre to have it
replaced.
2. REPAIRS
ATTENTION - Use only Felisatti accessories and spares.
Parts the changing of which is not covered in this
instruction manual, should be replaced in a Felisatti Official
Service Centre
(See Warranty/Official Service Centre address leaflet).
See general warranty conditions printed on the attached
sheet.
Code
927490170
927490170
927490170
927490170
927490170
927490170
927490170
fabric 927490170
attached sheet.
relating to old electrical and electronic appliances and
its translation into national law, used electric tools must
be collected separately and recycled in an ecologically
desirable way.
3. Some troubleshooting tips
Malfunction
When switch is ON the
motor does not start
Circular sparkling on the
collecting ring
Smoke or smell getting out
through ventilation slots
Increased noise in
gearbox
The spindle does not
rotate

WARRANTY

See general warranty conditions printed on the
DISPOSAL
WARNING! Do not dispose of electric tools in the
household waste!
In accordance with European Directive 2002/96/EC
Possible cause
Faulty switch
Faulty mains lead, wires,
plug
No contact between
contact brushes and
collecting ring
Worn out, faulty brushes
Worn out, drooping
brushes
Faulty armature coil
Faulty windings of motor
Faulty electrical part of
tool
Worn out, broken pinions
or bearings
Faulty or incorrectly
mounted rigging
Broken gearbox
9