Troubleshooting - Airthereal Pure Morning APH260 Bedienungsanleitung

TROUBLESHOOTING

Problem
No power or
response.
Any faulty display of
the LED numbers.
Unusual noise while
operating.
Significantly reduced
airflow.
Poor air purification
quality.
Cause
Unit is not plugged into
an electrical outlet.
Outlet is not working
properly.
Front cover is not properly
placed on the unit.
Power cord is damaged.
Air purifier is defective
or malfunctioning.
Auto Mode has just been
turned on.
Unit is defective or
malfunctioning.
Dirty filters.
Filters installed improperly.
Foreign object inside the
unit.
Flimsy or slanted surfaces
resulting in abnormal noise
and vibrations.
Not enough space around
the unit.
Surrounding area exceeds
the applicable area.
Air inlet or outlet is blocked.
Filter(s) not properly placed
in housing.
Solution
Connect the plug to a powered electrical
outlet.
Try plugging the air purifier into a different
outlet.
Properly replace the front cover as noted
in the Getting Started section.
Immediately discontinue use and contact
Customer Support.
Allow the air purifier to run for 30S. They
will change a stabilized status based on
the detected air quality
Immediately discontinue use and contact
Customer Support.
Replace the air filters as instructed in the
Replacing the Air Filters section on page 9-10.
Properly place filter as noted in the Getting
Started and Replacing the Air Filters
sections (page 9-10).
Immediately discontinue use and contact
Customer Support. DO NOT attempt to
open the air purifier.
Place air purifier on hard, flat surfaces.
Ensure that there is at least 15 inches
(38 cm) between the unit and other objects.
APH260 is applicable to 355 ft² (33 m²).
Remove objects that block the air inlet or
outlet.
Properly place filter as noted in the Getting
Started and Replacing the Filters sections
(page 9-10).
11