Setting Up The Laminator - SEAL 65 EL Handbuch

3.6 Setting up the laminator

Your 54/65 EL should be setup at the place where it will be used. The area must be a flat level
surface.
The machine must be installed next to a power outlet. The plug and the outlet must be easily
accessible. Please ensure that you plug your laminator into a grounded outlet. The laminator should
only be connected to a power supply outlet able to safely supply the voltage and amperage marked
on the ratings label.
1. Move the machine to the designated working space.
2. Install Image Guide on table as shown in figure 5.
Note: Image Guide is optional on some models.
3. Install Take-up Tube onto right side first compressing spring on the right side then inserting left
side onto drive (figure 5).
4. Plug the power cable into the grounded outlet with appropriate service.
Image
Guide
Figure 5
8
Note:
Make sure that the machine, in its final
location, has adequate space. You will
need room to feed, receive and trim
images. See Figure 4.
L = Maximum board length,
S = Minimum space 60 cm.(24").
Figure 4: Working Space
Take-up
Tube