Installation Steps - Ovislink AirLive WL-5460AP v2 Schnellinstallationsanleitung

Installation Steps

1. Please install your network cards first before the AP device
2. Screw-in the antenna (clockwise) into the Antenna connector
3. Connect the power and LAN cable to the back
4. Use your wireless card to do a site survey, the default SSID is airlive and Channel is 13
5. If you need to change AP's configuration, please follow the procedure below:
The AP's default IP address is 192.168.100.252. Please make sure your computer IP is in the same
subnet as the AP (i.e. 192.168.100.x)
Open the web browser and enter http://192.168.100.252/.
Wireless Mode Setup
This page includes all primary and major parameters for the wireless mode setting. Any parameter change will
cause the device to reboot for the new setting to take effect.
Wireless Modes: AP, Client, Bridge, WDS Repeater, Universal Repeater, WISP (Client Router),
WISP + Universal Repeater and Gateway (AP Router) mode
The default mode is set to AP. You can change it to another mode.
Network Type: When in Client mode, you can select between Ad-Hoc or Infrastructure.
WL-5460AP v2
English
5