Herunterladen Inhalt Inhalt Diese Seite drucken
Inhaltsverzeichnis

Werbung

ENG:

SAFETY WARNINGS

The product can only be installed by qualified personnel in compliance with local safety laws and regulations.
Fracarro Radioindustrie is free from all civil and criminal responsibility due to breaches of current legislation derived
from the improper use of the product by the installer, user or third parties.
The product must be used in full compliance with the instructions given in this manual, in order to protect the
operator against all possible injury and the product from being damaged.
Don't open the product case: components under dangerous voltage may be accessible when the case is opened.
Installation precautions
The product must not be exposed to water drips and must be installed indoors inside in dry places.
Damp and condensation drops could damage the product. Consequently, always wait for the product to be
perfectly dry before use.
Handle with care. Knocks could damage the product.
Leave plenty of space around the product to ensure sufficient ventilation.
High temperatures or overheating could compromise the product functions and life.
Do not install the product above or close to sources of heat, in dusty atmospheres or when it could be
exposed to corrosive substances.
In the event that the unit is fixed to the wall, use the proper screw anchors suitable to the characteristics of
the fixing support.
The wall and the anchoring system must be able to support at least 4 times the weight of the unit
Warning: to avoid injury, this appliance must be secured to the wall / floor depending on the installation
instructions.
The "PERMANENTLY INSTALLED UNITS" must be equipped with an easily accessible power disconnecting
switch easy to reach. "UNITS WITH A POWER PLUG," the outlet must be installed near the unit and easy to
reach.
The product must be connected to the ground electrode of the antenna system in accordance with EN
60728-11. The screw prepared for this purpose is marked with the symbol
the provisions of the EN 60728-11 standard and to connect this screw to the main earth node of the plant
(do not connect to intermediate points).
Class II symbol
Earth screw symbol of the antenna installation
General precautions
In case of a malfunction, do not attempt to repair the product because this would invalidate the guarantee. Only use
the feeder provided with the product.
The information given in this manual has been carefully prepared, however Fracarro Radioindustrie S.r.l. reserves
the right at any time, and without prior notice, to make any improvements and/or changes to the product described
in the manual. Consult the website of www.fracarro.com for the terms regarding assistance and the guarantee.
3
. It is recommended to follow

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Swa435ssaAmp435ssaSwa435sa

Inhaltsverzeichnis