Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Before starting up the machine, check that the blade can turn freely and is completely centred.
Disconnect the tool before checking the brushes.
The life of the brushes is variable. It depends on the workload of the motor. Check the brushes after every 50 hours of use if the tool is new
or after a new set of brushes is installed.
After the first check, inspect the brushes after every 10 hours of use until they need to be re-
placed.
The brush holders figure Zc are located on each side of the motor housing. Replace both brushes
if the carbon on one brush is worn and is only 5 mm long, or if a spring or a wire is burnt or da-
maged. If the brushes are still good for use, put them back in their initial position.
While using electric tools, always follow the basic safety rules in order to reduce the risk of
fire, electric shock and injury. Read all these instructions carefully before using the product and
keep these instructions for future reference.
22
INSPECTING AND REPLACING THE BRUSHES
IMPORTANT!
warning:
Werbung
Inhaltsverzeichnis
