Safety Advice; Intended Use; Installation Location; Installation Position - GOK PS 16 Montage- Und Bedienungsanleitung

SAFETY ADVICE

Your safety and the safety of others are very important to us. We have provided many
important safety messages in this assembly and operating manual.
Always read and obey all safety messages.
This is the safety alert symbol.
This symbol alerts you to potential hazards that can kill or hurt you and others.
All safety messages will follow the safety alert symbol and either the word
"DANGER", "WARNING", or "CAUTION". These words mean:
describes a personal hazard with a high degree of risk.
 May result in death or serious injury.
describes a personal hazard with a medium degree of risk.
 May result in death or serious injury.
describes a personal hazard with a low degree of
risk  May result in minor or moderate injury.
.
describes material damage.
 Has an effect on ongoing operation.
describes a piece of information

INTENDED USE

Operating media
• LPG (gas phase)
You will find a list of operating media with descriptions, the relevant
standards and the country in which they are used in the Internet at
www.gok.de/liste-der-betriebsmedien.
• is highly flammable
• may cause explosions
• severe burns in case of direct skin contact
Regularly check connections for leak-tightness.
If you smell gas or detect a leak, shut the system down immediately.
Keep ignition sources and electrical devices out of reach.
Observe applicable laws and regulations.
Place of operation
• operation in weatherproof and sun-protected outdoor areas

Installation location

• for being installed in two cylinder system or multiple cylinder system

Installation position

• do not install lower than gas cylinder valves
Pipes and hose assemblies from the double shut-off block which are connected to the
inlet connection of the pressure regulator must be installed at the highest possible
position, at least above the gas cylinder valve and must have a constant downward
incline to the tank or cylinder.
2 / 8
Escaping liquid petroleum gas (category 1):
Double shut-off block
describes a call to action
part no. 02 251 50 a