General Information; Tools And Accessories Required - Swim & Fun 1062 Anleitung

DK
1.

General information

1.1.1 Conditions for the installation of a Solar Board Heater
The Solar Board Heater you have purchased is intended for use with small garden pools, and is
easy to install and handle.
The installation instructions are based on the following conditions:
1. You have a pool which is fully built and filled with water.
2. Your pool has a filter system.
3. You have the required connector hoses to supply the pool and filter system with water.
(Ø 32/38 mm)
These are the requirements so that the Solar Board Heater can force water through the solar
chambers when it is installed and fully connected to the filter pump.
1.1.2 Use (Figure 1)
Once the equipment is installed, it is connected between your filter system and your pool using the
two hose connectors. The connector hose forces the cold water from your filter unit into the solar
chambers of your solar collector. Here it is heated by the sun's energy and then fed on to the se-
cond connector hose towards the pool.
A = feed from the filter unit to the solar collector
B = feed from the solar collector to the swimming pool inlet nozzles
Water heating depends on the following factors: Flow rate and level of sunshine.
Solar heating only functions efficiently in sunshine. It can also remain connected to the pump in
poor weather as this only causes a slight loss of pressure in the pump.

1.1.3 Tools and accessories required

These tools are required for assembly, but are not included in your set:
• Phillips screwdriver
• Flat head screwdriver
1.1.4 The ideal location for your solar collector
Your Solar Board Heater needs to be in a location with as much sunlight as possible.
• Never position the solar collector over the surface of your pool.
• Keep it an adequate distance away from your pool (keep a safe distance).
• The solar collector is designed to allow maximum possible penetration of sunlight.
MV-1062-11-2017 . © Alle rettigheder forbeholdes Swim & Fun Scandinavia ApS
23