LifeView FlyDVB Trio CardBus Anleitung Seite 3

©2006 by Animation Technologies Inc. All rights reserved.
Information in this document is subject to change without notice. No part of this document may
be reproduced or transmitted in any form or by any means, electronic or mechanical without
prior written permission of Animation Technologies Inc.
Animation Technologies Inc. makes no representation or warranties with respect to the
contents hereof and specifically disclaims any implied warranties of merchantability or fitness
for any particular purpose. Animation Technologies Inc. reserves the right to revise this
manual and to make changes in its content without obligation to notify any person or
organization of such revision or change. In no event shall Animation Technologies Inc. be
liable to you or any third party for any consequential, incidental, direct, indirect, special,
punitive, or other damages (including without limitation, damages for loss of profits,
interruptions, loss of information, pecuniary loss, etc.), even if Animation Technologies Inc.
has been advised of the possibility of such damages arising from any defect or error in this
manual or product.
Updates to this documentation can be obtained from our website: www.lifeview.com.
®
Windows is a trademark of Microsoft Corporation. All other brand names used in this
document are registered trademarks of their respective companies.
CE Statement: This equipment has been tested and complies with: EN 55022: 1998+A1:
2000+A2: 2003, Class B, EN 55024: 1998+A1: 20001+A2: 2003 (IEC 61000-4-2: 2001, IEC
61000-4-3: 2002+A12002, IEC 61000-4-4: 2004 (Not Applied), IEC 61000-4-5: 2001 (Not
Applied), IEC 61000-4-6: 2003+A1:2004 (Not Applied), IEC 61000-4-8: 2001, IEC
61000-4-11:2004 (Not Applied) ), EN 55013: 2001+A1:2003, EN 61000-3-2: 2000, EN
61000-3-3: 1995+A1:2001, EN 55020:2002+A1:2003 (S1, S2a, S2b, S3, S4, IEC
61000-4-2:2001, IEC 61000-4-3:2002+A1:2002, IEC 61000-4-4:2004).
FCC Statement: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and cause harmful
interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
Consult the dealer or an experienced radio/TV technician for help.
CAUTION: Changes or modifications not expressly approved by the party responsible for
compliance to the FCC Rules could void the user's authority to operate this equipment.
Copyright and Trademark Notice