User Instructions; Indicator Lights; Behaviour Upon The Failure And Resetting Of The Bus Power Supply; Maintenance - Gewiss Chorus GW 10 799 Installationshandbuch

The probe has a front LED that signals its operating status and load status (as per the
table).

Behaviour upon the failure and resetting of the BUS power supply

If power fails on the BUS, the device will not carry out any action. When the BUS power
supply resumes, the probe will reactivate the conditions that were in place prior to the
power failure.
The device does not require any maintenance. Use a dry cloth if cleaning is required.
Detailed information about how to set the probe parameters is given in the Programming
Manual (www.gewiss.com).
The device must be configured with the ETS software. Detailed information about the
configuration parameters and their values is given in the Technical Manual
(www.gewiss.com).

USER INSTRUCTIONS

Indicator lights

LED
Green
Red
Flashing red

Maintenance

Setting the parameters

Programming with ETS

Function
Probe operating
Solenoid valve active
No info about solenoid valve
status (if the status info
function is active)
17
E
N
G
L
I
S
H