Maintenance; Ce Declaration Of Conformity - Status Js550 Originalbetriebsanleitung

5. MAINTENANCE

MAINTENANCE
WARNING: Always ensure that the tool is switched off and unplugged before
attempting to perform inspection or maintenance.
LUBRICATION
All bearings have been pre-lubricated at the factory with a sufficient amount of high
grade lubricant for the life of the unit under normal operating conditions and no
further lubrication is required.
BRUSH REPLACEMENT
When the carbon brushes are worn out, the machine switches itself off. In this case
both brushes must be replaced simultaneously with genuine brushes at STATUS
service centre for warranty and post-warranty service.
GENERAL INSPECTION
Regularly inspect all fasteners and ensure they are properly tightened. Should any
of the screws be loose, retighten it immediately to avoid hazards. If the replacement
of the supply cord is necessary, this has to be done by the manufacturer or his
agent in order to avoid a safety hazard.
CLEANING
For safe operation always keep the machine and its ventilation slots clean.
Regularly check to see if any dust or foreign matter has entered the ventilation slots
and the grills around the switches. Use a soft brush and/or air jet to remove any
accumulated dust. Wear safety glasses to protect your eyes whilst cleaning.
Exterior plastic parts may be cleaned with a damp cloth and mild detergent if
necessary.
WARNING: Never use alcohol, petrol or other cleaning agent.
Never use caustic agents to clean plastic parts.
WARNING: Water must never come into contact with the tool.
NOTE: Power tools are subject to accelerated wear and possible premature failures
when sawing fibreglass, wallboard or plaster parts. The chips and grindings from
these materials are highly abrasive to bearings, brushes, commutators, etc. It is not
recommended to use the tool on these materials for continuous operation.
When sawing such materials it is extremely important to clean the power tool
frequently with compressed air.
IMPORTANT! To assure product safety and reliability, repairs, maintenance and
adjustment (including brush inspection and replacement) should be performed by
certifed service centres or other qualified service organisations, always using
genuine replacement parts.
WARRANTY The guarantee period for STATUS power tools is determined in the
guarantee card. Faults due to normal wear, overloading or improper handling will be
excluded from the guarantee. Faults due to defective materials implemented as well
as defects in workmanship will be corrected free of charge through replacement or
repair. The complaints for defective STATUS power tools will be recognized if the
machine is sent back to the dealer or is presented to the authorised warranty
service centre undismantled, in its initial condition.
EN
12

6. CE DECLARATION OF CONFORMITY

CE DECLARATION OF CONFORMITY
We STATUS ITALIA S.R.L. as the responsible manufacturer declare that the
following STATUS machine(s): Jig saw Model No./ Type: JS550
are of series production and сonforms to the following European Directives:
2006/42/ЕС , 2014/30/EU
And are manufactured in accordance with the following standards or standardised
documents: EN55014-1:2006, EN 55014-2:2015, EN 61000-3-2:2014,
EN 61000-3-3:2013, EN 60745-1:2009+A11, EN60745-2-11:2010, .
The technical documentation kept by the manufacturer: STATUS ITALIA S.R.L.,
via Aldo Moro, 14/A, 36060 - Pianezze (VI), ITALY
Caron Giacinto
Director
STATUS ITALIA S.R.L.
EN
13