Rebel RB-1010 Bedienungsanleitung Seite 35

Work mode selection
The power tool has two work modes: drilling without impact and impact drilling. Slide the
work mode switch (2) left to the marking for impact drilling; slide the work mode switch (2)
right to the marking for drilling without impact.
Use carbide-tipped drill bits and select impact drilling when drilling in hard materials such
as brick, tile, concrete etc.
Select drilling without impact when drilling with twist drills, hole saws etc., in soft materials.
Rotation direction adjustment (Fig.3)
The power tool has been equipped with rotation
direction switch (5) which is placed above the ON/
OFF switch:
• To achieve right rotation, push the rotation
direction switch (5) maximally left.
• To achieve left rotation, push the rotation
direction switch (5) maximally right.
NOTE: The drill will not run unless the rotation direction switch is pushed fully to the left or right.
Avoid running the drill at low speed for extended periods of time as it may cause the drill to
become overheated. If this occurs, cool the drill by running it without a load and at full speed.
Switching the power tool on and off
• Pressing the ON/OFF (7) switch will activate the power tool.
• Releasing the ON/OFF (7) switch will stop the power tool.
Lock-on button
This power tool has been equipped with lock-on button for continuous drilling.
To lock the ON/OFF switch:
• Press the ON/OFF switch.
• Press and hold the lock-on button (8) which is placed on the left side of the grip.
• Release the ON/OFF switch.
• Release the lock-on button.
• To release the lock, press and release the ON/OFF switch.
• If the lock-on feature is engaged during use and the drill becomes disconnected from
the power supply, disengage the lock-on immediately.
FIG. 3
35 EN