Niko-Servodan 41-926 Gebrauchsanweisung Seite 5

GB
Pulse is 5 seconds On and for 55 seconds Off.
The pulse function can be used e.g. to control ventilation
systems. The pulse function stops after the selected cut-off time,
after activity detection in the sensor's coverage area has ceased.
If this function is desired, first press "Pulse", then press one of
the "Time" buttons (not "8 Hours").
Example: The "Pulse" and "5 min" buttons are activated
via remote control. This means that after the final activity
registration, the sensor will pulse for five minutes. Fig. 2.
Test On/Off:
Activating walk-test.
When the test has been activated, the blue LED comes on. When
the detector detects activity in the coverage area, the red LED
and associated lighting will switch on for 5 seconds. The blue
LED is off when the associated lighting is on.
NB! The walk-test is daylight-independent.
Short push:
Has the same function (and limitations) as a short push given by
the operating button.
Long push:
Has the same function (and limitations) as a long push given by
the operating button.
Fact. setting:
Pressing this button immediately restores all settings to factory
settings.
5(13)
Servodan A/S | Tel +45 7442 4726 | Fax + 45 7442 4035 | info@servodan.dk | www.servodan.com