Inserting Batteries; Administrator Pin; Device Reset; Updating The Device - Silca Air4 Home Gebrauchsanleitung

Air4 Home
Please dispose of used ba eries in accordance with the local regula ons, and separately from household
waste. The device requires 2 x 1.5 V C-type alkaline ba eries (R14); these are pre-inserted in the device at the
me of purchase. Make sure that only new ba eries are used, every me that the ba eries are replaced. We
recommend using alkaline ba eries for a longer service life. The Air4 Home device has a rated voltage of 3.3
V and a power output of 0.3 W.
To replace the ba eries, proceed as follows (Fig./Abb.1):
1. Turn the device upside down, unscrew the 4 screws with a Phillips screwdriver and remove the ba ery
cover. (Fig./Abb.2)
2. Insert the new ba eries the right way around, so that the posi ve (+) and nega ve (-) ends are in the right
place, as indicated on the labels affi xed to the ba ery compartment. (Fig./Abb.3)
Only use and replace the old ba eries with ba eries that are a suitable size and type (alkaline, zinc-carbon
or zinc chloride).
IMPORTANT NOTE: There is a risk of explosion IF WRONG OR DAMAGED BATTERIES
ARE USED (e.g. if there is oxidation, liquid leaking or deformation).
When the device is fi rst switched on or reset (see the chapter 11), the device will prompt the user to choose
an 8-digit PIN via the app. The user can enter the PIN of their choice and use this PIN to access the Air4 Home
administrator func ons.
The PIN must therefore be safely stored by the owner of the Air4 Home, as it may be required if for
example, the user changes the smartphone that had previously been used to log in as an administra-
tor. The Air4 Home app provides the user with the option to securely save the PIN on the Silca Server,
by simply providing a recovery email address.
In the event that the PIN is no longer available or recoverable, the user must reset the device; this will erase
all the defi ned se ngs, such as the saved remote controls and authorised users.
The device reset allows the user to reset the Air4 Home to its factory se ngs, which in turn deletes all the
data.
PROCEDURE:
1. Access the ba ery compartment by loosening the two screws on the internal shell (Fig./Abb.7)
2. Hold down the Reset key (Fig./Abb.9) for approximately 10 seconds.
3. Release the key only when the LED starts fl ashing more rapidly.
4. Wait a few minutes for the device to complete the Reset opera on.
5. The opera on is complete only when the LED starts fl ashing again.
To reset the device, simply open the ba ery compartment and press the Reset bu on for a few seconds. (Fig./
Abb.9)
Air4 Home can be upgraded to a more recent fi rmware version using the Easy Scan Plus so ware (Air4 pro-
gramming so ware), which is available from the www.silca.biz website, and an adapter that is sold separately

9. INSERTING BATTERIES

10. ADMINISTRATOR PIN

11. DEVICE RESET

12. UPDATING THE DEVICE

Copyright Silca S.p.A 2019
English
11