Technical Specifications - Nibe HTS 40 Installateurhandbuch

MENU 7.2.11 - VENTILATION HEAT
EXCHANGER (ERS)
Highest fan speed
Setting range: 1 – 100%
Lowest fan speed
Setting range: 1 – 100%
Controlling sensor
Setting range: HTS 1 – 4
Highest fan speed
Here, you set the lowest permitted fan speed under
demand-controlled ventilation.
Lowest fan speed
Here, you set the highest permitted fan speed under
demand-controlled ventilation.

Technical specifications

HTS 40
Plastic spacer WxHxD
Dimensions WxHxD
Rated voltage
Part No.
HTS 40 | GB
Controlling sensor
Here, you select which exhaust air module(s) will be
affected by which HTS unit(s). If two or more HTS units
control an exhaust air module, the ventilation is adjusted
according the units' average value.
MENU 7.2.15 - HUMIDITY SENSOR (HTS)
climate system 1 HTS
Setting range: 1–4
limit RH in the room, syst.
Setting range: on/off
prevent condensation, syst.
Setting range: on/off
Up to four humidity sensors (HTS 40) can be installed.
Here you select whether your system(s) is/are to limit
the relative humidity level (RH) during heating or cooling
operation.
You can also choose to limit min. cooling supply and
calculated cooling supply to prevent condensation on
pipes and components in the cooling system.
(mm)
(mm)
(supplied from the heat pump/indoor
85x85x35
85x85x14
12 VDC 40 mA
module)
067 538
17