RAVPower RP-WD007 FILEHUB Handbuch Seite 19

FCC Notice
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
NOTE 1: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-Consult the dealer or an experienced radio/TV technician for help.
NOTE 2: Any changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.
FCC Radiation Exposure Statement:
This device meets the government's requirements for exposure to radio waves. The guidelines are
based on standards that were developed by independent scientific organizations through periodic
and thorough evaluation of scientific studies. The standards include a substantial safety margin
designed to assure the safety of all persons regardless of age or health. The SAR limit of USA (FCC)
is 1.6 W/kg averaged over one gram of tissue for body. Device types: FileHub (FCC ID:2AFDGRP-WD007)
has also been tested against this SAR limit. SAR information on this and other pad can be viewed on-line
at http://www.fcc.gov/oet/ea/fccid/. Please use the device FCC ID number for search. This device was
tested simulation typical 10mm to body. To maintain compliance with FCC RFexposure requirements, use
accessories should maintain a separation distance between the user's bodies mentioned above, the use of
belt clips, holsters and similar accessories should not contain metallic components in itsits assembly, the use
of accessories that do not satisfy these requirements may not comply with FCC RF exposure requirements,
and should be avoided.