Audica CX series Benutzerhandbuch Seite 9

Assembly of Speakers and Accessories
To attach the base to the CX-T floor
standing speaker (CX-System 3 only)
follow the diagram (right).
1. Lay the speaker down on a soft
surface and offer the base plate up
to the bottom of the speaker.
2. Make sure the threaded studs on the
speaker protrude through the
corresponding holes in the plate.
3. Screw on the nuts and gently
tighten using the spanner provided.
DO NOT OVERTIGHTEN.
4. For soft floor coverings we
recommend using the spikes. These
are fitted into threaded holes in the
base feet. The height of the spikes
can be adjusted from above using
the allen key provided. Alternatively,
for hard floor coverings you can use
the rubber feet in place of the
spikes.
5. Finish by fitting the Spike Caps into
the holes on the top of the glass
base.
9
1,2
3,4
GB