Speaker Connection - Audica CX series Benutzerhandbuch

Follow the steps below to setup and connect your speakers to your AV equipment. If you are in doubt about any aspect of
your other equipment then please refer to that manufacturers manual.
Satellites and Towers should be wired up as shown (below left). To prevent
speakers being wired out of phase, always use the printed strand (3) for the
positive red terminal (1) on both the speaker and the amplifier. If the satellite is
wall mounted or sat on a flat surface then thread the wires to the rear of the
speaker using the metal clip pin provided (2)
1
MODEL No. CX-S1
POWER HANDLING
60W-100W
FREQUENCY
80Hz-23KHz
IMPEDANCE
2
4 Ohms
DESIGNED
IN THE EU
MADE
IN P.R.C
3

Speaker Connection

Amplifier rear panel (actual panel may differ)
FL FR RL
+ + + +
CX-System 1 - CX-LCR (FL,FR)
CX-System 2 - CX-S (FL,FR) CX-S (RL,RR)
CX-System 3 - CX-T (FL,FR) CX-S (FL,FR)
6
GB
The Centre Speaker should be wired up as shown (below).
To prevent speakers being wired out of phase, always use the
printed strand (3) for the positive red terminal (1) on both the
speaker and the amplifier. Dress the cables out of the rear of
the speaker through the aperture in the terminal panel.
RR CEN
+
1
3
CX-System 1 - CX-LCR (CEN)
CX-System 2 - CX-C (CEN)
CX-System 3 - CX-C (CEN)
+
CX-C
FREQUENCY
POWER HANDLING MADE IN P.R.C
FRÉQUENCE PUISSANCE ADMISSIBLE
70Hz-35KHz 60W-120W Fabriqué en R.P.C.