Intended Use; Cutting Depth Adjustment - Worx Professional WU621 Übersetzung Der Originalanleitung

Symbols
To reduce the risk of injury, user must read instruction manual
Double insulation
warning
wear ear protection
wear eye protection
wear dust mask
waste electrical products must not be disposed of with
household waste. Please recycle where facilities exist. Check
with your local authorities or retailer for recycling advice
Operating instructions
Note: Before using the tool, read the instruction book carefully.

INTeNded USe

The machine is intended for planing of firmly supported wooden
materials, such as beams and boards. It is also suitable for beveling
edges and rebating.
1
SAFeTY ON/OFF SWITCH
The switch is locked off to prevent accidental starting. Depress the
lock off button (2) then on/off switch (1) and release lock off button
(2). The machine is working now. To switch off just release the on/off
switch .(See Fig. A)
2

CUTTING dePTH AdJUSTMeNT

Smaller cutting depth of 0-1mm (Max. 2.0mm) is best for most
surface planing or rebating. Rotate the cutting depth adjustment(4)
to set the required cutting depth on the scale ,Scale graduation =
0.125mm. The clockwise rotation increases the planing depth; the
counterclockwise rotation reduces the planing depth. (See Fig. B)
3
AdJUST dUST eXTRACTION ANd CHIP eJeCTION
Dust extraction can be adjusted to the right or left side by manually.
Rotating one end of the dust extraction (5) until it stops (See Fig.C).
The arrowhead on the dust extraction indicates the dust extraction
direction.
Note: due to the size and material of some wood shavings
e.g. wet or hard wood it is possible for the dust extraction
to become blocked. Remove the plug from the mains power
8