Optoma RD50 Themescene Bedienungsanleitung Seite 8

Power On
Step 1: Connect the power cord to the display as illustrated below.
Step 2: Switch on the main power switch located at the left side of the display as illustrated below.
Step 3: Press the power button on the front panel or remote control to turn on the display. The display
will turn on after a warm up period of approximately 30 seconds.
Power Off
Press the power button on the front panel or remote control once to turn off the display. For a period of 30
seconds after the power button has been pressed a second keypress will switch the unit back on immediately.
After 30 seconds the unit will begin the cool down process and will not be able to be switched back on for 2
minutes. Except in case of emergency, it is not recommended to use the main power switch to power off the
system. Lamp life may be severely reduced if the system is not allowed to cooled down properly by abruptly
shutting down the system using the main power switch.
NOTE:
1. The main power switch may be left on unless the unit will not be used for an extended period of time
2. The power button toggles between power on and power off. Please refer to the "Discrete IR code" section for user who
need the separate IR power on and power of IR code.
3. During the final phase of the cool down period the system will not respond to any power on or off commands. Wait until
the LED stops blinking to power up the display again.
Power On And Off The Display
RD65
Power cord
RD50
Power cord
RD65
Main power switch
Main power switch
7