Troubleshooting - Audio Design Renegade RX800A Betriebsanleitung

ENG

TROUBLESHOOTING

Malfunction: no function
Reason:
1. The power supply connection of the device is not correct.
2. The cabels have no mechanical or electrical contact.
3. The remote turn-on connection from the headunit to the amplifier is not correct.
4. Defective Fuse. In case of replacing the fuses, attend by any means the correct fuse rating.
)
Malfunction: no signal is audible, but power LED lights up
Reason:
1. The connection of the speakers or the RCA audio cables is not correct.
2. The speaker cables or the RCA audio cables are defective.
3. No signal from headunit.
Malfunction: distortions is audible
Reason:
1. The loudspeaker is overloaded.
Malfunction: no bass is audible
Reason:
1. Interchange of loudspeaker cable polarity positive (+) and negative (-).
2. The RCA audio cables are loose or defective.
Malfunction: hiss or white noise is audible
Reason:
1. The level controllers are turned up.
2. The speaker cables or the RCA audio cables are defective.
3. The hissing is caused by the headunit.
Remedy:
Recheck
Recheck
Recheck
Replace Fuse
Remedy:
Recheck
Replace cables
Check headunit settings
Remedy:
Turn down the level
Turn down the level on the headunit
Switch off loudness on the headunit
Reset bass EQ on headunit or amp
Remedy:
Reconnect
Reconnect or replacing the cables
Remedy:
Turn down the level
Replacing the cables
Check the headunit