Inhaltsverzeichnis
Werbung
AOSS Installation
If your Wireless Router/Access Point supports AOSS, then AOSS can configure your wireless network
for you. To configure your network with AOSS:
• Power on the Wireless Router/Access Point and the Ethernet Converter.
• Hold in the AOSS button on the Wireless Router/Access Point for 3 seconds.
• Hold in the AOSS button on the Ethernet Converter for 3 seconds.
AOSS will take about a minute to configure your wireless network. When finished, the AOSS LEDs on
both the Wireless Router/Access Point and the Ethernet Converter will stop blinking and stay lit. You
now have a secure connection!
NOTES: If AOSS is used in a network with existing non-AOSS wireless client devices, then they may
have to be manually re-configured afterward to reconnect to the Router/Access Point.
AOSS configures your SSID, encryption type, wireless channel, and encryption key, and
makes a secure connection between your wireless
components. You may still need to run your router's
configuration utility to connect to the internet.
If AOSS does not finish properly, power cycle both
the Router/Access Point and the Ethernet Converter
and rerun AOSS. AOSS works best when the router
and the Ethernet Converter are physically close. You
can always move them further apart when configuration is complete.
7
Quicklinks ausblenden:
Werbung
Inhaltsverzeichnis
