Maintenance - Deltaco DUR-900 Bedienungsanleitung

ENG - User Manual
Safety instructions
1. Do not look into or observe the device's light, neither directly or through an optical instrument.
2. Do not disassemble or remove the lens cover. If the lens cover is removed, your eyes will be directly exposed to the light.
4. Keep the product away from children.
Do not continue to use the product if it has been damaged or deformed. Do not leave it in hot environments.
Product information
This barcode scanner provides an accurate, fast and easy complete solution for data entry and storage for computer
information systems.
The product has two working modes: manual and auto-sensor.
This product provides 4 interfaces to connect to any host computer system: Keyboard (Keyboard wedge), RS-232, USB
HID and VCOM.
the device has been powered off.
This product has more settings than available barcodes in this manual. If needed you can create your own barcodes to set your
own settings. One example is the "LED on time", it has about 200 possible settings but only 4 examples of barcodes are in this
Scan barcodes
In order to obtain a good scan effect, you should aim the
barcode reader at the center of the barcode, but you can
aim from any direction.
The closer the scanner is to the barcode, the smaller the aiming beam is;
the farther away the scanner is from the barcode, the larger the aiming beam is.
If the barcode is small, the scanner should be close to the barcode; if the barcode is large, the scanner should be farther
away from the barcode, so the barcode can be read easily and correctly.
3
4
2
5
Cable removal
1. Locate the cable removal hole on the bottom of the scanner.
Readability VS performance
Each type of barcode has its own unique properties. Enable the ability to read barcode types via the settings found in this
manual. You can disable the scanner from reading barcode types that will not be used to improve the scanner's performance.

Maintenance

1. Stains and dust on the scan window may affect the scanning. Use a lint-free cloth / lens tissue of good quality to gently
wipe clean the window if needed. Poor quality paper will damage the surface smoothness of the scan window and affect
the scanner's effect.
2. The scanner's housing can be wiped with a clean soft cloth. When needed, moisten the cloth with water or a mild soap
solution and wipe it with a soft cloth.
1. Scan window
2. Button
1
3. LED
4. Sound output
5. Cable removal hole
for the corresponding setting you want to create or change.
1
.