How To Confirm Bridge Is Enabled; Access The Internet Using The Ethernet Port (Access Point) - Kingston MobileLite Wireless Pro Anleitung

How to Confirm Bridge is Enabled

Once the MLWPRO has restarted, you'll have to reconnect to the MLWPRO Wi-Fi network.
To verify that you have successfully enabled bridge mode:
1. Check the bridge status icon at the top of the screen is no longer grayed out.
2. If you return to the 'Wireless Network Setup' in 'Settings', you will see a red check mark next to
the connected network. Here you can click the 'x' to forget network if desired.
3. The bridged LED will light up on the MLWPRO device indicating the device has internet access.
Also, while connected to MLWPRO, open an Internet browser and enter a URL, like Kingston.com, to
confirm you have internet access.
1

Access the Internet Using the Ethernet Port (Access Point)

If you have a wired internet connection, you can plug an Ethernet networked cable to the Ethernet port on
the MLWPRO. This would allow you to create an access point for wireless internet access. While
connected to the Ethernet bridge mode, the Wi-Fi bridge mode will be disabled until the Ethernet cable is
removed.
NOTE: Only compatible with DHCP.
Simply connect an Ethernet networked cable to the
Ethernet port on the MLWPRO device. Check that
bridged LED is ON to verify that you have a
successful connection to the router.
If you haven't already, make sure to connect to the
MLWPRO network.
Document No. Android-MLWPRO-011816.A00
Bridge
Enabled
MobileLite Wireless Pro
2
Bridged LED
Bridged
LED
3
Page 25 of 30