Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Programming the controller Rain Evo
In order to program Rain Evo you need only 3 buttons:
The
button (enter) to move from a screen to another one and to confirm
the set information.
+
The
button (incr.) to modify or increase data.
The
button (Man./Back) to confirm the weekly calendar, to active the
manual open and to come back to the previous screen.
Note:
During programming session, after 20 seconds without pushing any button the controller will
come back to the first screen and will be saved only the confirmed information.
Setting the Date and Time
Once batteries are connected, first the controller auto resets, than the display will appear as
the figure; the minutes icon starts flashing.
+
Press the
button to increase the units minutes
Press the
button and the tens minutes icon starts flashing.
+
With
button increase tens minutes
Follows the same procedure for hour unites and hour tens
Press the
button and the slash under the weekly days starts flashing
+
Press the
button to move the slash under the current day
Press the
button to confirm and proceed to the next operation
Note:
To get midnight you should set 00 as time and not 24.
1
Setting Days to water
Choose the specific day in which irrigate:
Press the
button and the slash under the day starts flashing
+
Press the
button to move the slash under the day selected
Press the
button to change the current set up
Therefore:
button to set or remove the watering days.
At the end press the
button to confirm all your settings and the
to come back to the main screen (current hour).
To change your settings press the
button and follow the procedure above
described.
Now your controller is programmed and the display will appear as the figure
Your settings
Current day
To change your setting:
button to go into the setting
+
button to go in the screen you would change
3
+
button
Current hour
Watering Days
Setting Watering Start Times
Press the
button and the units minutes will flash.
+
Press the
button to set minutes units of first watering start times and fol-
low the same procedure to set the other units of current hour.
Note:
To get midnight you should set 00 as time and not 24.
Setting Length of Watering
Leaving in OFF position the program, the area will be inactive.
Press the
button and the three zeros for the setting of the length watering will be
active .
The set of the length is in minutes (time minimum 1 min. - time maximum
360 min.)
Press the
button and the minutes units start flashing.
Set the length of watering following the usual procedure:
and
button to confirm and proceed to the next operation.
Note:
To reach the OFF position set at zero the length watering.
The display appears as the figure during irrigation (count down).
Manual Watering
Rain Evo has set a manual watering of 3 minutes, to change the length press the
from minimum 1 min. to maximum of 360 min.
Press the
button to open manually the valve.
To change the minutes of watering, press the
button.
Otherwise after 20 sec., the controller will start automatically with the 3 minu-
tes of watering.
Press
button to stops the manual watering.
I and II irrigation
+
button to set
Irrigation
count down
Run Watering
+
button and modify the setting,
+
button and confirm with
2
4
Werbung
