2
Assembly
2.1 Attaching the back
During transit, the back of the chair
is removed. Prior to use, therefore,
the back must be mounted. Place left
C
metal sleeve A over the long pin B - as
A
shown in the picture. Th en place the
right sleeve C over the short pin D. After
D
B
this, press the back all the way down on
the pins so that it meets the bottom.
C
D
2.2 Power Supply
To enable the chair's electronic functions
to be used, it must be connected to
mains power. Th e supplied adaptor
must be used here.
HEPRO
User Manual | Side 29