Samson AirLine 99m Bedienungsanleitung Seite 6

AR99m Receiver Features
Antennas - The antenna mountings allow
1.
full rotation for optimum placement. In
normal operation, both antennas should
be placed in a vertical position. Both
antennas can be folded inward for
convenience when transporting the
AR99m.
SET Button - Press this button for more
2.
than 2 seconds to enter scan mode, the
display will flash quickly. The receiver
will scan through the 100 operating
channels to find the optimal channel for
performance. Once the scan is complete,
the AR99m will enter IR Set mode
and send the selected channel to the
transmitter.
Press and hold the button for more than
10 seconds to enter IR set mode, the
display will flash slowly. This will send
the receiver's current selected channel to
the transmitter.
LED Display - The two digit, 7-segment LED display shows the receiver's current operating
3.
channel.
READY Indicator - This indicator lights green when the CR99m is receiving RF signal and
4.
the system is ready to use.
IR Transmitter - During "IR SET" an infrared light is used to set the transmitter channel.
5.
PEAK Indicator - This indicator lights
6.
red when the transmitted audio signal is
overloaded.
VOLUME / Power Control - This rotary
7.
knob controls the level of the receiver
output and powers the AR99m on
and off. Turn the control clockwise
to turn the system on. Turn the knob
counterclockwise until it clicks to turn
the system off.
USB Port - This USB port provides 5V
8.
200mA of power which can be used
to charge the AH9 headset transmitter
(AR99m only passes power to the USB
port when the power is ON). It can also
be used to connect an optional Samson
XPD USB Digital Wireless receiver to this
input, turning the AR99m into a dual
wireless system.
6
7
1
8
5
4 6
2 3
1