Cassette Recorder - Philips AZ1018 Bedienungsanleitung

Cassette Recorder

CASSETTE RECORDER
Cassette playback
1 Adjust the POWER slider to TAPE/
2 Press STOP•OPEN 9/ to open the
cassette door and insert a recorded
cassette.
3 Close the cassette door.
4 Press PLAY 1 to start playback.
Display: shows tAPE throughout tape
operation.
5 To pause playback press PAUSE ;.To
resume, press the key again.
6 By pressing 5 or 6, fast winding of the
tape is possible in both directions.To stop
fast winding, press STOP•OPEN 9/.
7 To stop the tape, press STOP•OPEN 9/.
• The keys are automatically released at the
end of the tape, the tAPE indication goes
out and the set is switched off, except if
PAUSE ; has been activated.
12
General information on
recording
• Recording is permissible insofar as copyright
or other rights of third parties are not
infringed.
• This deck is not suited for recording on
CHROME (IEC II) or METAL (IEC IV) type
cassettes. For recording, use only NORMAL
type cassettes (IEC type I) on which the
tabs have not been broken.
. • The best recording level is set automatically.
OFF
Altering the VOLUME and DBB controls
will not affect the recording in progress.
• At the very beginning and end of the tape,
no recording will take place during the
7 seconds when the leader tape passes the
recorder heads.
• To protect a tape from accidental erasure,
have the tape in front of you and break out
the left tab. Recording on this side is no
longer possible.To record over this side
again, cover the tabs with a piece of
adhesive tape.
Recording