Werbung
Verfügbare Sprachen
Verfügbare Sprachen
• Operating above maximum rated pressure and flow.
• Not draining, and allowing water to freeze inside the nozzle.
• Dropping the nozzle from a height where damage is incurred.
• Prolonged exposure to temperatures above +130 degrees F, or below -25 degrees F,
• Operating in a corrosive environment.
• Other misuse that might be unique to your specific fire fighting environment.
There are many "tell tale" signs that indicate nozzle repair is in order, such as:
• Controls that are either inoperable or difficult to operate.
• Excessive wear.
• Poor discharge performance.
• Water leaks.
If any of the above situations are encountered, the nozzle should be taken out of service and repaired, plus tested
by qualified nozzle technicians, prior to placing it back in service .
OPERATING INSTRUCTIONS
• To change the spray angle, push the toggle switch to either SS (straight stream) or fog.
• To change the 750 gpm flow rate, remove the baffle head and .118" thick spacer and install the 1000 gpm spacer
( . 2 18" thick) or use no spacer for 500 gpm .
• To flush the nozzle push the toggle switch towards the fog position until it stops. This gives you the maximum orifice
for clearing small debris .
MAINTENANCE
• Under normal conditions, periodically flushing the nozzle with clean water and cleaning grit and dirt from around
exterior moving parts will allow the nozzle to operate as designed .
• Periodically (at least annually), lubricate the pattern sleeve with Low-Temp Lubripate by using the grease fitting on the
side of the pattern sleeve .
• Over time the O-Rings may need to be replaced. This can be accomplished by purchasing the appropriate O Rings
shown on the service parts list . Use qualified maintenance mechanics or return the nozzle to Akron Brass for repair .
ISO 9001 REGISTERED COMPANY
PHONE: 330 . 2 64 . 5 678 or 800 . 2 28 . 1 161 I FAX: 330 . 2 64 . 2 944 or 800 . 5 31 . 7 335 I akronbrass . c om
WARRANTY AND DISCLAIMER: We warrant Akron Brass products for a period of five (5) years after purchase against defects in materials or workmanship . Akron Brass will repair or replace product
which fails to satisfy this warranty . Repair or replacement shall be at the discretion of Akron Brass . Products must be promptly returned to Akron Brass for warranty service .
We will not be responsible for: wear and tear; any improper installation, use, maintenance or storage; negligence of the owner or user; repair or modification after delivery; damage; failure to follow
our instructions or recommendations; or anything else beyond our control . WE MAKE NO WARRANTIES, EXPRESS OR IMPLIED, OTHER THAN THOSE INCLUDED IN THIS WARRANTY STATEMENT,
AND WE DISCLAIM ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR ANY PARTICULAR PURPOSE . Further, we will not be responsible for any consequential, incidental or
indirect damages (including, but not limited to, any loss of profits) from any cause whatsoever . No person has authority to change this warranty .
© Akron Brass Company . 2011 All rights reserved . No portion of this can be reproduced without the express written consent of Akron Brass Company .
REVISED: 8/11
Werbung
