Troubleshooting - MiDRONE ADVENTURE Benutzerhandbuch

NOTE: After the flight, if the left joystick of the remote control remains in the default center position for
more than three seconds, the LEDs of the drone will again flash quickly awaiting for a new setting of the
flight direction. Proceed from step 1 again to set the flight direction.
HIGH / LOW SPEED
The H and L buttons are used to change the flight speed forwards / backwards / leftwards /
rightwards of the drone. The default setting when the remote is turned off is on low speed.
Press H button, the remote will beep twice to warn that the high speed mode is selected.
Press L button, the remote will beep once to warn that the low speed mode is selected.
PHOTO AND VIDEO
Please make sure that a micro SD card is inserted in the camera slot before taking photos and
videos. The card must be SDHC type of max. 32GB and must be formatted in FAT32 file
format. Press Photo button once to take a picture. Press video button once to start recording
video. Press this button again to stop recording.
360° ROLLOVER (3D FLIP)
When you are piloting the drone well in hand, you can now perform tricks of style!
Method 1
Fly the drone up to 3 meters height. Press the 3D Rollover
1 button on the remote control and the drone starts its
forward roll (default).
Method 2
Fly the drone up to 3 meters height. Press and hold the 3D
Rollover 2 button on the right side of the remote control,
and use the right joystick to control rollover direction to
achieve a 360° rollover forward, back, left or right .

TROUBLESHOOTING

Problem
The remote control does
not work at all
The controls do not work
properly
Mode / Direction Lock. The remote will beep once and the LED
lights of the drone keep fixed to confirm disabling this mode.
Cause
1. The batteries are used
2. The batteries are not well
installed
3. The ON/OFF switch is on OFF
1. The drone battery is not correctly
installed
2. The remote control and drone are
not synchronized
Solution
Remplace the batteries
Check polarity indications and insert the
batteries in the right direction
Power ON the remote control
Verify the connection of the battery
Start again the synchronization
procedure explained in this manual