Installation Of The Camera - MiDRONE ADVENTURE Benutzerhandbuch

2. Charging and installing the Li-Po battery
Plug the USB connector of the charging cable to a USB port on your
computer or USB charger (not included), and the other end directly to
the battery cable. The charge indicator LED will light in red on the
charger.
It takes about 60 minutes for the lithium battery to be fully charged.
The red LED indicator light turns off when the battery full.
Install the fully charged battery into the compartment provided for this purpose below the drone and plug
the cable into the drone's power plug as shown on the left image.

INSTALLATION OF THE CAMERA

Proceed as described below to install the camera. Warning, only that specific camera provided by
Midrone is compatible with this product.
INSTALLING PROTECTIONS AND REPLACING THE PROPELLERS
Install protection in the direction of the arrows as shown in the picture
on the right.
Screw protection when it is in place.
If a propeller replacement is necessary pay special attention to
the direction of rotation. More details in the illustration at
right. The propellers that rotate clockwise are marked with a
letter A. Those that rotate in the anti-clockwise direction are
marked with a letter B.
NOTE: The installation of accessories increases the weight of the drone and can affect the flight time.